ATOMIUM MOTOTEC-2 100 - two stroke engines oil additivive

Tribotechnical compound MOTOTEC 2 produced by ATOMIUM is designed to restore the performance and protect against wear the two-stroke engines of mopeds, all-terrain vehicles (quad bikes), outboard motors, chainsaws and other equipment, including engines with separate lubrication system.

EFFECT OF APPLICATION:

• Restores compression
• Increases power
• Decreases fuel and oil consumption
• Decreases vibration and noise level
• Decreases hum in the gearbox and improves vehicle's free-run
• Decreases exhaust CO/CH emissions
• Increases the lifetime

USING INSTRUCTION:

Compound MOTOTEC 2 is added to the working oil of the engine by the following procedure:

1. Warm up the engine to operating temperature.
2. Stop the engine.
3. Shake the can thoroughly until the natural sediments (active components) are dissolved completely.
4. Add the compound in the engine through its regular oil filling neck.
5. Apply half of the can only - if engine has separate lubrication system. If engine has common lubrication system, compound has to be applied at the rate of 5 ml of compound per 1 liter of oil.
6. Start the engine and take a trip lasting 15-20 minutes in normal driving mode at once after the procedure.

FULL ENGINE TREATMENT IS PERFORMED AS FOLLOWS:

With separate lubrication system:

1st STAGE
1. 1/2 of can into the oil tank
2. Work up to emptying the oil tank
3. Work on a clean oil up to emptying the oil tank

2nd STAGE
1. 1/2 of can into the oil tank
2. Work up to emptying the oil tank

Full treatment is done. To maintain the performance of the engine is recommended subsequent treatment after 30-40 hours of engine operation.

With common lubrication system:

1st STAGE
1. 5ml of ATOMIUM per 1l of fuel into the fuel tank
2. 5-6 working hours
3. 20 working hours on the clean fuel

2nd STAGE
1. 5ml of ATOMIUM per 1l of fuel into the fuel tank
2. 5-6 working hours

Full treatment is done. To maintain the performance of the engine is recommended subsequent treatment after 30-40 hours of engine operation.