ATOMIUM REDUCER 80 - oil additive for differential /trans.boxes

The "Reducer" tribotechnical compound is designed to protect against wear, extend the service life and restore the properties of the differential, increased friction, etc., which use any type of fluid.

The "Reducer" Tribotechnical Compound is designed to protect against wear, extend the service life and restore the properties of transmission boxes, limited slip differential, viscous clutches, haldex clutches, increased friction reduction, and other reductive elements that use any type of transfer fluid.

USAGE

Treatment of transfer cases, differentials and other reducers is made in accordance with the following procedure:

1. Warm up the unit to operating temperature (regular operation). It takes usually 15-20 minutes of unit operation under load.
2. Stop the engine
3. Shake the can thoroughly until natural sediments (active components) are totally dissolved.
4. Apply 1 can of the compound through unit’s regular filling neck. 1 can is enough for treatment of the unit with transmission fluid volume from 0.7 to 2.2 liters.
5. It is recommended to drive the car for no less than 25 - 30 min. in mode of regular operation after applying.

After the procedure you can use the car as usual.

To provide continuous level of protection of the unit it is recommended to apply the compound further after each scheduled replacement of transmission fluid.

EFFECTS

• Decreases noise and vibration level
• Increases the car free run (in neutral gear)
• Increases engine lifetime